It’s a bar bearing support equipped with a roller. It can be used in addition to the roller table. It should be suitably ballasted or fixed to the floor. Roller 550 mm wide, max load 750 Kg, H min 840 mm / H max 1.015 mm.
Code: C2

The band saw machine can be equipped of a blade and cutting cooling device. To improve the cutting quality and reduce pollution risk, moreover to avoid the risk of pools of cooling liquid on the floor (possible cause of accidental falls), we suggest to use the NB optional.
Code: NB1 Box-NB2 Box

In the pulpit control panel version, the control panel may be placed according to the production necessities of the Costumer.
Code: QEL

Device for vertical clamping of the material, hydraulic cylinder and manual positioning. During the cutting cycle the vertical cylinder works together with the vice for the material clamping.
Code: DOTM

The closing pressure adjustment of the vice RPM1,decreasing from the standard machine max. pressure, is used for materials having thin thickness and consequently that can be easily deformed. It is not possible to reduce the pressure value adjusted by the hydraulic system pressure switch under the safety value of 6 bar.
Code: RPM1

The SENS optional is assembled on the flywheel. In case the blade collapses due to an insufficient tension exerted by the stretcher or in case it goes stuck into the piece during the cut, the work cycle would immediately stop. In this way the SENS optional protects the motor wheel and the blade itself.
Code: SENS

The machine may be equipped with a measure shaft for 1 to 6 meters (3.3 to 19.7 ft) measure stops to be installed on the RFP roller tables.
Code: FM..RSP

2 m long roller table with idle rollers 550mm wide, max load 1000 Kg/m (h min 925 mm/h max 980 mm).
Code: RFP2

This option allows a considerable reduction in working times: it speeds up the descent of the blade and decreases its lifting speed. On the head there is a fast approach device allowing the rapid approach of the blade when this is near the work piece to be cut. After cutting, the blade goes back only what is strictly necessary out of the piece and it is immediately ready for the next cut.
Code: TM

The Nebula Oil fluid is an eco-friendly high quality lubricant which can be used for all mechanical works of chips removal on iron metals and light alloys. Its high lubricant property reduces the friction of the tool on the material during the working operation and inhibits the development of heat, which is the first cause of tool wear and of the bad quality of the worked surface. Available in packs of 5Kg.
Code: Nebula Oil