It’s a bar bearing support equipped with a roller. It can be used in addition to the roller table. It should be suitably ballasted or fixed to the floor. Roller 550 mm wide, max load 750 Kg, H min 840 mm / H max 1.015 mm.
Code: C2

The band saw machine can be equipped of a blade and cutting cooling device. To improve the cutting quality and reduce pollution risk, moreover to avoid the risk of pools of cooling liquid on the floor (possible cause of accidental falls), we suggest to use the NB optional.
Code: NB1 Box-NB2 Box

Device for vertical clamping of the material, hydraulic cylinder and manual positioning. During the cutting cycle the vertical cylinder works together with the vice for the material clamping.
Code: DOTM

The closing pressure adjustment of the vice RPM1,decreasing from the standard machine max. pressure, is used for materials having thin thickness and consequently that can be easily deformed. It is not possible to reduce the pressure value adjusted by the hydraulic system pressure switch under the safety value of 6 bar.
Code: RPM1

The SENS optional is assembled on the flywheel. In case the blade collapses due to an insufficient tension exerted by the stretcher or in case it goes stuck into the piece during the cut, the work cycle would immediately stop. In this way the SENS optional protects the motor wheel and the blade itself.
Code: SENS

With automatic striker positioning.
System equipped with a measuring striker with automatic positioning controlled by a  programmable electronic panel. Feeding is made by a pinion on rack through a gear box controlled by an inverter. Tilting striker arm equipped with a locking brake  with springs shocks absorber. 550 mm wide idle rollers, diameter 70 mm and max loading capacity of 1000 Kg/m. 
H min 925 mm/H max 980 mm.
Code: CNP

The machine may be equipped with a measure shaft for 1 to 6 meters (3.3 to 19.7 ft) measure stops to be installed on the RFP roller tables.
Code: FM..RSP

2 m long roller table with idle rollers 550mm wide, max load 1000 Kg/m (h min 925 mm/h max 980 mm).
Code: RFP2

Our motorized roller can be joined to all models of FMB band saws so that any movement is avoided during the cut. Its moving is electrical and its lifting power is 1.500 Kg.

Code: RM - Rullo motorizzato

Unloading side connection between the basement of the Pegasus DS+VHZ and the RFP2 roller table.
Code: CRS-PEG DS