Additional unloading side surface to cut heavy material.
Code: PUSO

Device for vertical clamping of the material, hydraulic cylinder and manual positioning. During the cutting cycle the vertical cylinder works together with the vice for the material clamping.
Code: DOTM

To facilitate the handling and the loading of very long pieces it has been created the optional RPP (specifically for Pluton Air).
On the loading side of the band saw machine it is placed an idle roller moving pneumatically . During loading of the material to be cut, when vices are open, the roller lifts up facilitating the pieces sliding. When vices close, the roller lowers. At the end of the cut the roller automatically lifts up to facilitate the subsequent load.
Code: RPP

The closing pressure adjustment of the vice RPM1,decreasing from the standard machine max. pressure, is used for materials having thin thickness and consequently that can be easily deformed. It is not possible to reduce the pressure value adjusted by the hydraulic system pressure switch under the safety value of 6 bar.
Code: RPM1

This optional allows you to adjust the pressure of the clamping of the cutter vice and the carriage vice. Adjustment must be made separately for each vice and is done by hand, using the handwheel of the valve. The pressure gauges let you read the pressure change (in bar).
Code: RPM2

A milled roller placed on the loading side for the material feeding in manual mode. Lifting system with lever and eccentric, tough hand wheel for the rotation and gear box to make the material feeding easier.
Code: RRTR

The RTR optional allows to move the material to be cut manually in a safe and easy way. By means of an eccentric lever, the material rises from the basement, even when very heavy, and with the help from a manual hand wheel the piece to be cut can be moved forward and backwards.
Code: RTR

The “SD –stress detector” optional surveys this stress from the motor ampere increase. Before the situation gets critical, the SD slightly lifts the blade from the material and then makes it get down for a no trouble cutting. During all these phases the blade keeps turning. The lapse of time of blade lifting is chosen by the Customer.
Code: SD

The SENS optional is assembled on the flywheel. In case the blade collapses due to an insufficient tension exerted by the stretcher or in case it goes stuck into the piece during the cut, the work cycle would immediately stop. In this way the SENS optional protects the motor wheel and the blade itself.
Code: SENS

This option allows the sawing machine to cut round material whit a diameter up to 540 mm
(21.3 inch.). When using this optional, it is necessary to replace the blade protection guard positioned in the upper part, between the motor flywheel and the neutral flywheel (NB the special guard is equipped with the optional SHO).
Code: SHO