OPTIONAL PLUTON AIR

With this option the cutting cycle start can be executed using a pedal.

The option LX facilitates the operator during the cutting phase: a luminous red line is projected on the piece locked in the vice to exactly display where the blade will make the cut.

The band saw machine can be equipped of a blade and cutting cooling device. To improve the cutting quality and reduce pollution risk, moreover to avoid the risk of pools of cooling liquid on the floor (possible cause of accidental falls), we suggest to use the NB optional.

Specific for Pluton Air. At about 270 mm from the work top, over the pushers, it is placed a suction hood of processing fumes. The output is arranged for connection of 2 nozzles where apply the vacuum cleaner (not supplied).

With this option QEL SMART the operator can put the control panel in the position He prefers, the connection cable is 2,5m long.

To facilitate the handling and the loading of very long pieces it has been created the optional RPP (specifically for Pluton Air).
On the loading side of the band saw machine it is placed an idle roller moving pneumatically . During loading of the material to be cut, when vices are open, the roller lifts up facilitating the pieces sliding. When vices close, the roller lowers. At the end of the cut the roller automatically lifts up to facilitate the subsequent load.

The SENS optional is assembled on the flywheel. In case the blade collapses due to an insufficient tension exerted by the stretcher or in case it goes stuck into the piece during the cut, the work cycle would immediately stop. In this way the SENS optional protects the motor wheel and the blade itself.